{"id":59,"date":"2019-03-19T08:49:00","date_gmt":"2019-03-18T23:49:00","guid":{"rendered":"http:\/\/quarterrampskate.psilk.com\/en\/?page_id=59"},"modified":"2019-03-19T08:49:00","modified_gmt":"2019-03-18T23:49:00","slug":"reinforcement","status":"publish","type":"page","link":"http:\/\/quarterrampskate.psilk.com\/en\/reinforcement","title":{"rendered":"Reinforce"},"content":{"rendered":"

I understood it, but after all only right and left of the edge decided to put reinforcement with a quarter pipe of 225cm in width most because it was bad in terms of strength that there was only a vertical board<\/p>\n

\"Reinforce<\/a><\/p>\n

Because I cut and brought down R two pieces of right and left from one piece of veneer, veneer of such a form is left. Using this, I intend to make parts reinforcing a Ramp.<\/p>\n

\"Reinforce<\/a><\/p>\n

I cut it to rough size<\/p>\n

\"Reinforce<\/a><\/p>\n

After trial and error, I made such parts<\/p>\n

<\/p>\n

\"Reinforce<\/a><\/p>\n

It is good when I put it together!!<\/p>\n

\"Reinforce<\/a><\/p>\n

Lean it near the middle….<\/p>\n

\"Reinforce<\/a><\/p>\n

These two parts formed it and were able to enter the center.<\/p>\n

It is no use with such a small reinforcement parts and reinforces it steadily afterwards after all<\/p>\n","protected":false},"excerpt":{"rendered":"

I understood it, but after all only right and left of the edge decided to put reinforcement with a quarter pipe of 225cm in width most because it was bad in terms of strength that there was only a vertical board Because I cut and brought down R two pieces of right and left from one piece of veneer, veneer of such a form is left. Using this, I intend to make parts reinforcing a Ramp. I cut it to rough size After trial and error, I made such parts<\/p>\n","protected":false},"author":1,"featured_media":62,"parent":0,"menu_order":20,"comment_status":"open","ping_status":"open","template":"","meta":[],"yoast_head":"\n\n\n\n\n\n\n\n\n\n\t\n\t\n\n\n\t\n