set up Coping
Coping flows too much after coming through frightful hardships, and having put R mask
In addition, I tear off the veneer of the R side, and a fine adjustment does it again
The coping is difficult.
Though I think as such and intended to come to here, I can never permit it and appear too much
I tear off the R mask which I put with much effort once and make a fine adjustment
I sandwich the small veneer
I make a fine adjustment for such a feeling
Even this is no use and adds a little thinner veneer and makes a great effort. Seriously serious
By the way, if the fine adjustment is over, too, and I have finished putting an R side somehow, and thinks……
It is found out that coping neighborhood is warped on the table side by “power” which is going to return of the veneer slightly
Is it so indeed if I think?
When it is this state, some copings leave only the middle
The power to push from the table side to the R side if I attach a table well is reservation in working first of all
Balance is difficult after a long absence when I make a Ramp
I classify reinforcement into the most important rafter of the coping moiety and…..
Using edge materials, I put it in all later after all
