Reinforce
I understood it, but after all only right and left of the edge decided to put reinforcement with a quarter pipe of 225cm in width most because it was bad in terms of strength that there was only a vertical board
Because I cut and brought down R two pieces of right and left from one piece of veneer, veneer of such a form is left. Using this, I intend to make parts reinforcing a Ramp.
I cut it to rough size
After trial and error, I made such parts
It is good when I put it together!!
Lean it near the middle….
These two parts formed it and were able to enter the center.
It is no use with such a small reinforcement parts and reinforces it steadily afterwards after all
