set up surface
Even a jump Ramp is a quarter Ramp, but when I make even a mini-Ramp, it is the reasonable making, pasting up of “”R side having a hard time and is serious
I accept the reinforcement of the entrance first. I in this way think whether it is the strength that, as is expected, is good because the entrance repeats three pieces of 5.5mm veneer because it is 16.5mm
I was considerably particular about an angle. If an angle here is not good enough, I come, and calyx っと is unpleasant when I enter. I put it many times again and was serious（笑）
I set the 5.5mm veneer which I add length and cut
If I gradually tighten it using the belt (rushing belt) of the ratchet and come to the good place, I hit the course thread。
Very very awesome!!!
Even 5.5mm veneer is a strong thing. It had a hard time really badly to put（汗）
Besides, it is serious even once so as to get tired
I do not like “appearance” of the coping and make a fine adjustment over and over again later
I put R mask again and did it three times each time
It is serious so as to get tired lol lol
